TROUBLE SHOOTING GUIDE
PROBLEM
Engine will not start (see Engine Manual for further engine troubleshooting)
No or low pressure (initial use)
CAUSE
No fuel.
Pressure builds up after two pulls on the recoil starter or after initial use.
Choke lever in the "No Choke" position.
Spark plug wire not attached.
Engine switch in OFF position.
Choke lever in the "Choke" position on a "hot" engine or an engine that has been exposed to thermal heat for a long period of time.
Spray wand not in high pressure.
Low water supply.
Leak at high pressure hose fitting.
Nozzle obstructed.
Water filter screen clogged. Air in hose.
Choke in the “Choke” position.
High pressure hose is too long.
CORRECTION
Add Fuel.
Squeeze gun trigger to relieve pressure.
Move choke to the "Choke" position.
Attach spark plug wire.
Place engine switch in ON position.
Move choke to the "No Choke" position.
See How to Use Spray Wand instructions in the Operation Section.
Water supply must be at least 5 GPM @ 20 PSI.
Repair leak. Apply sealant tape if necessary.
See Nozzle Cleaning instructions in the Maintenance section.
Remove and clean filter.
Turn off the engine, then the water source. Disconnect the water source from the pump inlet and turn the water source on
to remove all air from the hose. When there is a steady stream of water present, turn water source off.
Move choke to the “No Choke” position.
Use high pressure hose under 100 feet.
A20116 | 18- ENG |
