OPERATING INSTRUCTIONS
Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.
Chemical
SprayHose
Gun
Gatling
Spray
High
Wand
Pressure Hose
| High Pressure |
| Pump (located |
| inside the |
| shroud) |
| Engine |
BASIC ELEMENTS OF A | BASIC ELEMENTS OF AN |
PRESSURE WASHER | ENGINE |
High Pressure Pump (located inside the shroud): Increases the pressure of the water supply.
Engine: Drives the high pressure pump.
High Pressure Hose: Carries the pressurized water from the pump to the gun and spray wand.
Spray Gun: Connects with spray wand to control water flow rate, direction, and pressure.
Gatling Spray Wand: Allows the user to quickly change
Chemical Hose: Feeds cleaning agents to the pump to mix with the water. See How To Apply Chemicals/ Cleaning Solvents instructions in this section.
Refer to the engine manual for location and operation of engine controls.
Choke Control: Opens and closes carburetor choke valve.
Starter Grip: Pulling starter grip operates recoil starter to crank engine.
Engine Switch: Enables and disables ignition system.
PRESSURE WASHER
TERMINOLOGY
PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc.
GPM: Gallons Per Minute. The unit of measure for the flow rate of water.
CU: Cleaning Units. GPM multiplied by PSI. GPM x PSI = CU
A20116 | 10- ENG |
