Exide S47-0079 manual Viewing Charge Information, Charge Time

The 046-0371 control can provide an auto-refresh charge as long as the battery remains connected to the charger if enabled. If AC power is lost during the wait period, the control resumes from where it left off after power is restored. During the auto-refresh charge, the amp-hours and charge time are added to the original charge. The refresh charge consists of 30 minutes at the equalize current. To change the auto-refresh settings, refer to the programming section.

2.1.8 Viewing Charge Information

Additional charge information is available any time by pressing the INFO button. This information is retained after the battery is disconnected until the next battery is connected. After 20 seconds the display returns to the default display of amps and volts per cell. The following information can be viewed:

Parameter	DISPLAY	DESCRIPTION
Charger State	XXXXXX	Message describing charger state.
Amps	CHARGER DC AMPS	Charger current in amps.
	AA: xxxA
Volts/Cell	BATTERY V/C	Battery voltage in volts per cell (v/c).
	VC: x.xxVC
Amp Hours	ACCUMULATED AH	Amp Hours returned for the current (or last) charge cycle.
	AH: xxxxAH
Charge Time	CHARGE TIME	Charge time for the current (or last) charge cycle in hours and minutes.
	TC: xx:xxHM
Percent Return	% AH RETURNED	Percent of Amp Hours returned as a function of battery AH rating.
	PR: xxx%
Voltage	BATTERY VOLTS	Total battery voltage in volts.
	VV: xx.xV
End Current	CHARGE END AMPS	End current for the last charge cycle (current amps if charging)
	EA: xxxA
End Voltage	CHARGE END VOLTS	End voltage for the last charge cycle (current voltage if charging)
	EV: x.xxVC
Software	SOFTWARE VERSION	Control software version
	SW: x.xx

10