Operation
Push the lever forward and down to disengage the brake.
The unit must be tied down and brake engaged when transporting.
Ignition Switch
Located on right fuel tank console.
The ignition switch is used to start and stop the engine. The switch has three positions “OFF”, “ON” and “START”. Insert key into switch and rotate clockwise to the “ON” position. Rotate clockwise to the next position to engage the starter (key must be held against spring pressure in this position).
Note: Brake must be engaged, motion control levers out (neutral lock position), and PTO switch “OFF” to start engine. (It is not necessary for the operator to be in the seat to start the engine.)
Drive Wheel Release Valves
Located on the top left front corner of hydrostatic pumps.
Drive wheel release valves are used to release the hydrostatic drive system to allow the machine to be pushed without the engine running.
With a 5/8 inch wrench, turn both valves one turn counterclockwise to release drive system. Turn clockwise to reset system. Do Not overtighten. Do
Not tow machine.
PTO Engagement Switch
Located on right fuel tank.
Switch must be pulled out to the “ROTATE” position to engage the blades. Switch is pushed in to the “STOP” position to stop the blades.
Hour Meter
Located on the right fuel tank console.
The hour meter is connected to a pressure switch installed in the engine block and it records the number of hours that the engine has run. If the ignition switch is left on without engine running, hour meter will not run.
Note: This switch is not a low oil sensor and will not alert the operator if the engine oil is low.
Hydraulic Lift Switch
Located on right fuel tank console.
The hydraulic lift switch is used to raise and lower the mower deck.
Push the front portion of the hydraulic lift switch down to raise the mower deck to the desired height.
Push the rear portion of the hydraulic lift switch down to lower the mower deck to the desired height.
Fuel Shut-Off Valve
Located in fuel line by fuel tank and fuel filter.
The fuel
Rotate the valve 1/4 turn clockwise to shut off fuel. Rotate the valve 1/4 turn counterclockwise to turn on fuel.
Fuel Gauge
Located at the rear of the right fuel tank.
The fuel gauge monitors the amount of fuel in the right fuel tank only. The left tank does not hold fuel.
Pre-Start
Fill fuel tanks. For best results use only clean, fresh regular grade unleaded gasoline with an octane rating of 87 or higher. Regular grade leaded gasoline may also be used; however, combustion chamber and cylinder head will require more frequent service. See Engine Owner’s Manual.
Do Not add oil to gasoline.
Do Not overfill fuel tank. Never fill the fuel tank so that the fuel level rises above a level that is 1/2 inch (13 mm) below the bottom of the filler neck to allow for fuel expansion and prevent fuel spillage.
Make sure you understand the controls, their locations, their functions, and their safety requirements.
19
