Maintenance
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
WARNING
While maintenance or adjustments are being made, someone could start the engine. Accidental starting of the engine could seriously injure you or other bystanders.
Remove the key from the ignition switch, engage parking brake, and pull the wire(s) off the spark plug(s) before you do any maintenance. Also push the wire(s) aside so it does not accidentally contact the spark plug(s).
WARNING
The engine can become very hot. Touching a hot engine can cause severe burns.
Allow the engine to cool completely before service or making repairs around the engine area.
Recommended Maintenance Schedule(s)
Maintenance Service | Maintenance Procedure | |
Interval | ||
| ||
|
| |
After the first 5 hours | • Change the engine oil. | |
|
| |
After the first 100 hours | • Check the wheel hub locknuts torque specification. | |
|
| |
After the first 250 hours | • Change the hydraulic filter. | |
|
| |
| • Check the engine oil level. | |
| • Check the safety interlock system. | |
| • Check the rollover protections systems (roll bar) pins. | |
Before each use or daily | • Check the seat belt. | |
| • Check for loose hardware. | |
| • Clean the engine cooling system. | |
| • Remove accumulated debris from engine. | |
|
| |
| • Check the hydraulic oil level. | |
| • Check the tire pressures. | |
Every 40 hours | • Check the condition of the belts. | |
| • Grease hitch and cylinder pivots. | |
| • Grease the dual tail wheel pivot (if applicable). | |
|
| |
Every 50 hours | • Service the air cleaner. (May need more often under severe conditions. See the Engine | |
Owner’s Manual for additional information.) | ||
| ||
|
| |
Every 80 hours | • Remove the engine shrouds and clean the cooling fins. | |
|
| |
Every 100 hours | • Change the engine oil. (May need more often under severe conditions.) | |
• Grease the fold pivot pin. | ||
| ||
|
| |
| • Lubricate the brake handle pivot. | |
| • Lubricate the brake rod bushings. | |
Every 160 hours | • Lubricate the motion control bronze bushings. | |
| • Lubricate the steering linkage rod ends. | |
| • Check the spark plugs. | |
|
| |
Every 500 hours | • Check the wheel hub locknuts torque specification. | |
|
|
23
