Operation

Product Overview

Figure 4

1.

Fuel Cap

4.

Seat Belt

2.

Roll Bar

5.

Motion Control Lever

3.

Controls

6.

Parking Brake Lever

 

 

 

 

Operation

Note: Determine the left and right sides of the machine from the normal operating position.

Controls

Motion Control Levers

The motion control levers located on each side of the console control the forward and reverse motion of the machine. The levers control the flow of hydraulic oil from the hydrostatic pump to the drive wheel motor for each side.

Moving the levers forward or backward turns the wheel on the same side forward or in reverse. Wheel speed is proportional to the amount the lever is moved.

Moving the levers outward from the center position into the T-slot locks them in the neutral position (Figure 6).

Throttle Control

Located on right fuel tank console.

The throttle is used to control engine speed. Moving the throttle lever forward will increase engine speed and moving the throttle lever to the rear will decrease engine speed. Moving the throttle forward into the detent is full throttle.

Park Brake Lever

Located on left side of unit, between the seat and the dummy tank.

The brake lever engages a parking brake on the drive wheels.

Pull the lever up and rearward to engage the brake.

Push the lever forward and down to disengage the brake.

The unit must be tied down and brake engaged when transporting.

Ignition Switch

Located on right fuel tank console.

The ignition switch is used to start and stop the engine. The switch has three positions “OFF”, “ON”

17

Page 17
Image 17
Exmark Diesel manual Product Overview, Operation, Controls