c)To tighten alternator belt, loosen both upper and lower alternator mounting bolts. Rotate alternator out, away from engine and
d)When properly tensioned, the alternator belt will deflect
4.2.4Park Brake Adjustment:
Check to make sure each brake is adjusted properly.
a)Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
b)Tilt seat forward and raise hood.
FIGURE 9
c)Disengage the park brake. Measure the length of the park brake spring. The spring should measure 2.5” (6.4cm). See Figure 10.
FIGURE 10
d)If necessary, turn the thin nyloc nut to obtain the 2.5” (6.4cm) spring length.
e)Engage the park brake. Measure the gap between the thin nyloc nut and the park brake clevis. The gap should measure 1/8” (3.2mm)
FIGURE 11
f)If necessary, loosen the inner flanged nut and turn the outer nut to obtain the 1/8” (3.2mm) gap.
g)If park brake does not fully disengage when the lever is disengaged check the brake rod linkage assembly. The assembly should measure
33
