Programmer’ser’sGuide,Guidecont’d
The switcher’s rear panel
1 | 6 | 6 | 1 |
|
| ||
5 | 9 | 9 | 5 |
|
|
Female Male
Figure 4-1 — RS-232 connector pin arrangement
The
The protocol is 9600 baud,
Host-to-Switcher Instructions
Pin |
| Function |
1 | — | Not used |
2 | TX | Transmit data |
3 | RX | Receive data |
|
|
|
4 | — | Not used |
5 | Gnd | Signal ground |
|
|
|
6— Not used
7— Not used
8— Not used
9— Not used
The switcher accepts SIS commands through the
Switcher-Initiated Messages
When a local event such as a front panel operation occurs, the switcher responds by sending a message to the host. The
(C) Copyright 2002, Extron Electronics “CrossPoint 42 HVA”, Vx.xx
The copyright message is initiated by the switcher when it is first powered on. Vx.xx is the firmware version number.