Extron electronic CTL208CM Quick Start Guide CTL208CM

CTL208CM Control Panel Module • Quick Start Guide

CAUTION

Installation and service must be performed by authorized

personnel only. These units must be installed in

accordance with national and local electrical codes.

Step 1

Power off all devices and disconnect them from the power source,

if necessary.

Step 2

Run the serial cable between the control panel module’s installation

location and the device to be controlled.

Step 3

As necessary, install a wall box, table connector bay, or other mini-

AAP mounting option into which the control panel module will be

installed.

Step 4

Configure the control panel module’s rear panel DIP switches.

Step 5

Connect a serial cable between the control panel module and a

computer.

Step 6

Connect the external power supply to the control panel module.

Step 7

Program the control panel module’s buttons as desired, using either

the Extron ICS100 control software or the Extron ASCII character

command set.

Step 8

If necessary, set the control panel module’s serial control settings to

match those of the device to be controlled using the Extron ASCII

character command set.

Step 9

Disconnect the serial control cable from the computer and install the

serial control cable between the control panel module and the device

to be controlled.

Quick Start Guide — CTL208CM

QS-1

Contents

Main Users Manual CTL208CM Extron Electronics, USA Extron Electronics, Europe Extron Electronics, Asia Extron Electronics, Japan Precautions Safety Instructions English Instrucciones de seguridad Espaol Consignes de Scurit Franais Sicherheitsanleitungen Deutsch Quick Start Guide CTL208CM Quick Start Guide CTL208CM, contd Chapter 1 Introduction Chapter 2 Installation Chapter 3 Operation Table of Contents CTL208CM Control Panel Module Table of Contents Table of Contents, contd Chapter One Introduction About the CTL208CM Features ii Appendix Reference Information Introduction About the CTL208CM Figure 1-1 Typical CTL208CM application Features 1-2 Chapter Two Installation CTL208CM Control Panel Module Installation 2-2 2-3 Installation Figure 2-2 Grounding outer braided and foil shields 2-52-4 UL Requirements for Wall Box Installation Extron CTL208CM Extron RGB 478 Mxi Figure 2-1 CTL208CM in a four-gang wall box Wall Mounting Site Preparation Device Configuration 2-72-6 Figure 2-3 Attaching a wall box to a stud Rear Panel Setup and configuring the CTL208CM are on the rear panel (figure 2-7). Figure 2-7 Rear panel view 2-9 2-8 Wall Mounting 2-10 2-11 Switch Function On (1) On (1) 1 Serial mode * If the CTL is the last unit in a daisy chain. RS-485 RS-422 Chapter Three Operation CTL208CM Control Panel Module OperationCTL208CM Control Panel Module Operation Operation, contd Button Modes 3-2 3-3 Operation CTL208CM Control Panel Module Operation Operation, contd Chapter Four Serial Communications ICS100 Windows Control Program Serial Commands 3-4 Factory Reset Serial Communications 4-2 4-3 ICS100 Windows Control Program Figure 4-2 Serial Port Setup window System requirements Using the software to program the CTL208CM Figure 4-4 Connected window 4-6 4-7 Figure 4-6 Toggle Mode Timeout window Figure 4-7 Button Codes window 4-8 4-9 Using the help system Serial Commands Communication protocols Command and response structure Addressing the unit CTL208CM Control Panel Module Serial Communications Control panel module responses Figure 4-8 Button numbers Using the command/response table 4-10 4-11 Command/response table for programming the CTL208 Button code programming 4-12 4-13 Command ASCII Command Response Additional description 4-14 4-15 Button timeout programming Button group programming (continued) Button group programming Serial port parameters A Appendix 4-16 Reference Information Specifications Parts List Reference Information A-2 Specifications Control/remote General Reference Information, contd Wall mounting harware