Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
AFL
Disable AFL EOGLOK}Glok0]Disables global input lock/AFL
(default).
Enable input lock E1GLOK}Glok1]Locks the output refresh rate to the
refresh rate of the selected input.
View AFL setting EGLOK}X3*] View the current input lock/AFL
setting.
View AFL status E41STAT}X3(]
41Stat•X3(]
View the current input lock/AFL status.
(verbose mode response)
Video signal presence
View signal presence E0LS}X3%*X3%*X3%]Input 1*2*3.
On-Screen menu configuration
Menu time-out
NOTE: Setting the time-out to 501 disables the OSD time-out (never times out). Setting the time-out to 0 disables the OSD.Set menu time-out EX2!MDUR}MdurX2!]Set the OSD to X2! seconds
View time-out EMDUR}X2!]V iew time-out settings
Reset commands
Reset all device
settings to factory
default settings 24
EZXXX}Zpx]
Information request
General information I/i VidX!•TypX#•StdX1)•BlkX2^•HrtX1@•VrtX1@]
Query firmware
version
Q/q x.xx]View firmware version.
Query full firmware
version
*Q/*q x.xx.xxxx]View full firmware version details.
Query Boot Loader
version, factory
firmware version,
and current
firmware version.
0Q x.xx-x.xx.xxxx-x.
xx.xxxx]
View boot loader version, view factory
firmware version, view current firmware
version.
Query part number N/n 60-1253-01]View part number.
View internal
temperature E 20STAT}Stat20•X1!] Temperature in degrees Celsius.
NOTE: X! = Input selection: 1 to 3 X# = Input video format: 1 = RGB, 2 = YUV, 3 = Composite, 4 = HDMI
X1) = Input standard output selection: 0 = No signal detected, 1 = NTSC 3.85, 2 = PAL, 3 = NTSC 4.43, 4 = SECAM
- = N/A (occurs when input is an active RBG, YUV [but not NTSC/PAL], or an HDMI signal)
X1! = Internal temperature (in degrees Celsius)
X1@ = Horizontal and vertical frequencies (format is three-digit with single decimal and leading zeros for example, 075.3
X2! = On-screen menu time-out: (default = 60 seconds), output sync time-out (default = 501 - never),
0 = OSD never displayed and output sync is instantly disabled with no active input,
1 to 500, in 1 second increments,
501 = OSD never times out/output sync never times out
X2^ = Video mute; 0 = Off or disable, 1 = On or enable (mute to black), 2 = mute all output sync and video
X3% = Video signal status: 0 = Video or TMDS not detected, 1 = Video/TMDS detected
X3* = Input AFL: 0 = Disabled (default), 1 = Input signal AFL enabled. See command description on page 25 for variable details.
X3( = Input AFL status: 0 = Input signal lock disabled, 1 = Input signal lock enabled, but cannot lock to applied input signal.
2 = Input signal lock enabled, output locked to applied input signal. See command description on page 25 for variable details.
DSC 301 HD • SIS Communication and Control 35