Installation and Operation, cont’d
1U Universal Rack Shelf | 1/2 Rack Width |
| Front False |
| Faceplate 1/4 Rack Width |
| Front False |
| Faceplate |
Both front false faceplates use 2 screws.
Use 2 mounting holes on opposite corners.
(2)
Figure 2-3 — Under-desk mounting
Figure
5. | Secure the shelf to the rack using the supplied machine |
| screws. |
Furniture mounting
The transceiver can be mounted under a horizontal surface using an optional MBU 125
1. | If rubber feet were previously installed on the bottom of |
| the unit, remove them. |
2. | Secure the |
| transceiver with the four machine screws provided in the |
| mounting kit (figure |
3. | Hold the transceiver with attached brackets against the |
| underside of the desk or other furniture. Mark the location |
| of holes for screws on the desk. |
4. | Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot |
| holes in the table or desk at the marked screw locations |
| from the underside or inside (the concealed side) of the |
| furniture, where the transceiver will be located. |
5. | Insert the four wood screws into the pilot holes. Fasten |
| each screw into the installation surface until just less than |
| 1/4" of the screw head protrudes. |
6. | Align the installed screws with the slots in the mounting |
| brackets, and place the transceiver against the surface, |
| with the screws through the bracket slots. |
7. | Slide the transceiver slightly forward or back, then tighten |
| all four screws to fasten it in place. |
FOX | FOX |