Extron electronic Quick Start Guide - FOX HD-SDI, Step, FOX HD-SDI Quick Start Guide QS-1

Receiver with Loop-through

Quick Start Guide — FOX HD-SDI

NThe FOX HD-SDI is a transceiver that can function as a transmitter and/or a receiver. At least two units are required for a transmitter-receiver system with at least one fiber optic cable linking each two units. The FOX HD-SDI is available in single mode or multimode versions.

Connect and operate two or more FOX HD-SDI units as follows:

Step 1

Power off all equipment. If desired, mount the units in racks.

Step 2	MODE				MODE				MODE
Use the rear panel
				1 down				1 down
Mode DIP switches
to configure each				2 down				2 up
unit to be installed		1	2			1	2			1	2
	Bidirectional				Transmitter
in the system as
	Transceiver

a bidirectional

transceiver, a transmitter, or a receiver as shown above right.

1up

2down

NThe drawings below and on QS-2 show the signal flow for the three different FOX HD-SDI configurations. For more information on the various modes and their capabilities, see "Transceiver configurations" in chapter 1, "Introduction".

Step 3

Transmitting unit — Connect an HD-SDI, SDI, or 3G-SDI video source to the unit's HD/SDI In BNC connector.

HD/SDI IN

Step 4
Transmitting unit —	Video			Video from
If the FOX HD-SDI	Source	To Receiver		Source
is configured as a		FOX HDSDI
transmitter, and if desired,	POWER
		OPTICAL
	12V	MODE
connect one or two local	0.3A MAX
				1	2
monitors to the unit's	HD/SDI IN
		Tx	Rx	BUFFERED OUTPUTS
Buffered Outputs BNC	Transmitter
connectors. These two
BNCs output the same
HD-SDI, SDI, or 3G-SDI video that was input in step 3.

Step 5

Both units — Connect	OPTICAL	Tx Rx
the transmitting unit's
a fiber cable between
Optical Tx connector

and the receiving unit's Optical Rx connector.

OPTICAL Tx Rx

FOX HD-SDI • Quick Start Guide QS-1