Extron electronic setup guide HFX 100 Series Setup Guide, Installation, b ad, Mounting, Extron

HFX 100 Series • Setup Guide

The Extron HFX 100 Series consists of a transmitter (HFX 100 Tx) and receiver (HFX 100 Rx) that use one multimode fiber optic cable to extend a HDMI signal up to 984 feet (300 m).

This guide provides basic instructions for an experienced installer to set up and operate the HFX 100 Series extender (see the HFX 100 Series User Guide, at www.extron.com, for full instructions).

Installation

Step 1 — Mounting

Mount the HFX 100 Tx close to the HDMI source and the HFX 100 Rx close to the HDMI display device. See the HFX 100 Series User Guide for all mounting options. Follow the instructions provided with the appropriate installation kit.

Step 2 — Cable Connections

HFX 100 Series Front Panel HFX 100 Tx Rear Panel HFX 100 Rx Rear Panel

b

a d

Extron

POWERER	HFX 100 Tx
12VV
00..33AAMAXX

OUTPUT

INPUTI

POWERER	HFX 100 Rx	b
12V
00..22AAMAXX
	INPUTI	f

OUTPUT

c

e

1.Connect one of the provided 12 VDC power supplies to the front panel captive screw connectors of the transimtter and the other to the receiver (B).

ATTENTION: Before connecting power to the HFX 100 Tx or Rx, see the attention box in the “Power Supply” section of the HFX 100 Series User Guide for important information about power supplies.

NOTES:

• When the units receive power but no input signals, the front panel LED (A) lights

amber.

• When the transmitter receives power and a HDMI input signal, the front panel LED

lights green

• When the receiver receives power and a fiber optic input signal, the front panel LED lights green.