A12 VDC power input — Connect the provided 12 VDC power supply to the front panel captive screw connectors. When power is provided to the unit but there is no DVI input, the front panel lights amber.
Back Panel
Power Receptacle
POWER 12V 1.0A MAX
DC Power Cord
Captive Screw Connector
Ground +12 VDC
External
Power Supply
(12 VDC, 1 A )
AC Power Cord
Figure 4. 12 VDC Power Connection to HFX 100
ATTENTION:
•Always use a power supply provided by or specified by Extron. Use of an unauthorized power supply voids all regulatory compliance certification and may cause damage to the supply and the end product.
•Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling spaces or in wall cavities. The power supply is to be located within the same vicinity as the Extron AV processing equipment in an ordinary location, Pollution Degree 2, secured to the equipment rack within the dedicated closet, podium, or desk.
•The installation must always be in accordance with the applicable provisions of National Electrical Code ANSI/NFPA 70, article 75 and the Canadian Electrical Code part 1, section 16. The power supply shall not be permanently fixed to building structure or similar structure.
NOTES:
•The length of the exposed wires in the stripping process is critical. The ideal length is 3/16 inch (5 mm). If it is any longer, the exposed wires may touch, causing a short circuit between them. If it is any shorter, the wires can be easily pulled out even if tightly fastened by the captive screws.
•Do not tin the wires. Tinned wire does not hold its shape and can become loose over time.
BHDMI input connector — Connect a HDMI input to this male connector.
NOTE: With appropriate
When the transmitter is receiving HDMI input signal, the front panel LED lights green.
HFX 100 • Panels and Cabling | 4 |