VersaTools® MDA 3 Series, cont’d
Back of the rack mounting
The MDA can be mounted to the rear of a rack using the Extron MBB 100 VersaTools® back of the rack mounting kit
(part
Rear
1
2
3
| I |
4 | NP |
UTS |
5
6
7
8
1
2
3
O | UTP |
4 | |
| UTS |
5
6
7
8
ENTER
PRESET
Figure 3 — Attaching the back of the rack kit
AV
VID
AUD
MA |
|
| |
M | V S |
| |
I/ATRIX | ERI | ||
O |
| SW | ES |
+dB |
| ITCHER | |
- |
|
|
|
dB |
|
|
|
AUDIO |
|
| |
| SETUP |
|
Front
DISTRIBUTION AMPLIFIER
1. Remove feet from the bottom of the MDA if they are installed.
2. | Remove two screws from one side of the unit. Retain the | Figure 4 — Typical back of the rack installations |
| screws for possible later reassembly without the bracket. |
|
3. | Attach one bracket to the side of the unit using the longer |
|
| screws included in the kit. |
|
4. | Repeat steps 2 and 3 on the other side of the unit. |
|
5. | Mount the unit to the rack using the two included rack |
|
| screws (figure 4). The MDA can be vertically mounted |
|
| facing in either direction. |
|
Only VersaTools products and most IP Link products can be mounted using the back of the rack mounting kit.
4 | VersaTools | ® | MDA 3 Series • Installation | VersaTools | ® | ® | 5 |
|
| MDAVersaTools3 Series •MDAConnections3 Series •andInstallationControls |