MGP Series Setup Guide
The MGP Series are
•MGP 464/MGP 462xi — Standard models with BNC input connectors that accept RGB, component video,
•MGP 464 DI/MGP 462xi DI — An MGP 464/462xi with a DVI input card installed, providing four DVI input connectors.
•MGP 464
•MGP 464W/MGP 464W DI — Designed for WindoWall™ video wall systems and available in sets of two or three processors. These models have no front panel controls and are controllable only via software. Each MGP displays up to four windows.
This guide provides procedures for installing all
MGP 464 and MGP 462xi models, and for configuring all models except the MGP 464W series. To configure the MGP 464W models (done via software only), refer to the WindoWall Console help file or the WindoWall Console Quick Reference card.
Installation
1. | Install the four rubber feet on the bottom of the |
| MGP, or mount the unit using the supplied rack |
| mounting brackets. |
2. | Turn off power to the input and output devices, and |
| remove the power cords from them. |
MBD 249
2U Rack Mounting Bracket (Use four lower holes.)
3. Connect the input sources to the MGP's BNC, DVI,
and/or | Rack mounting the MGP | |
accept the following signal types: | ||
|
RGB/HD/video inputs 1, 2, 3, and 4 — RGB, component video,
1RGBHV Video
G/Y | H/HV |
VID |
|
B/C | V |
|
1RGBS or RGBcvS
G/Y | H/HV |
VID |
|
B/C | V |
|
1RGsB or
Component
Video | |
G/Y | H/HV |
VID |
|
B/C | V |
|
1
G/Y | H/HV |
VID |
|
B/C | V |
|
1Composite
Video
G/Y | H/HV |
VID |
|
B/C | V |
|
DVI inputs 1, 2, 3, and 4 — These inputs can be used instead of, or in combination with,
analog inputs 1 through 4. (However, the MGP cannot process input from two different source devices connected to DVI and BNC connectors with the same input number — for example, input 1— at the same time). The DVI inputs are available only on the MGP 464/462xi DI and
NAnalog is not available on these DVI-I connectors.
NStandard definition SDI is not supported on these HD-SDI inputs.
INPUT
INPUT
06 09