Extron electronic MGP 462XI HD-SDI, MGP 464 HD-SDI Executive Mode Non-WindoWall Models Only

MGP 464 and MGP 464W Setup Guide (cont'd)

Executive Mode (Non-WindoWall Models Only)

To prevent accidental changes to settings, executive mode locks all panel controls except Freeze, input selection, Preset Recall/Save, and the RS-232/422 and Ethernet ports.

To enable/disable executive mode, press the Window/Image Size and Window/Image Position buttons simultaneously, and hold them down for 2 seconds.

Setting Up the MGP Using the Front Panel (Non-WindoWall)

After you have installed and connected the MGP, follow these steps to use the MGP front panel to configure and adjust the unit to get it ready for use. If installing a WindoWall processor (MGP 464W series), refer to the WindoWall Console help file or the WindoWall Console Quick Reference card for information on configuring via software.

Configuring the MGP

Press the Menu button to access the Main menu, shown at right. Then, repeatedly press the Menu button to cycle through the menus and access the Input Configuration, Output Configuration, and Advanced Configuration menus to perform steps 1 through 4.

1. Use the Input Configuration menu to configure inputs 1 through 4.

NThe virtual inputs (5 through 19) can be configured only via the Windows-based control software, SIS commands, or the Web pages.

2.	Use the Output Configuration menu to configure the output signal
	type and the output rate for the desired resolution.
3.	From the Advanced Configuration menu, Test Pattern submenu,
	Select the Alternating Pixels (Alt. Pixels) test pattern. Adjust your
	display's active pixels, total pixels, and pixel phase settings for
	optimal picture quality.
4.	From the Advanced Configuration menu, change the test pattern to
	Crop, and adjust your display's positioning until all four sides of the
	crop pattern are visible.
Adjusting the picture controls
5.	Use the Window Configuration menu to select a border color for each
	window. This aids in window sizing and positioning.
6.	Select input 1 for all windows.
7.	Adjust all windows to full screen. On the non-WindoWall models,
	this can be done using presets, as follows:

• If the MGP is set to factory defaults, select default window preset 1, 31, 61, 91, or 121 to set the windows to full screen size:

a. Press the Preset Recall/Save button.

b. Navigate to the desired preset and press Enter.

• If the default presets have been replaced or changed, follow these steps to set up the windows:

a. Press one of the Window Select buttons to select a window.

b. Use the Window/Image Position and Window/Image Size buttons with the Adjust knobs to set the window position to 0,0 and set the window size to match the output rate.

NMake sure that the LCD window displays Window and not Image while you are making the adjustment.

c. It may be necessary to mute windows to see other windows below them. To mute a window, select it, then press the input button for the selected window. The input button blinks, indicating that the window has been muted.

d. Repeat steps a through c for each remaining window.

Power

on

Extron

MGP 46X VX.XX

	2 sec.
	Multi-Graphic		Default
			Cycle
	Processor	2 sec.
	Menu
	Auto
	Image	20 sec.
	Menu
	Input
	Configuration	20 sec.
	Menu
	Output
	Configuration		20 sec.
	Menu
	Window
	Configuration		20 sec.
	Menu
	Background
	Capture	20 sec.
	Menu
	Comm. / IP
	Configuration	20 sec.
	Menu
	Advanced
	Configuration	20 sec.
	Menu
Menu	Exit Menu
	Press Next		20 sec.

Next

MGP Series • Setup Guide 3