Extron electronic MLS 100 A Quick Start Guide - MLS 100 Series, Step, Aux/Mix Input Wiring

Quick Start Guide — MLS 100 Series

To install and set up the MLS 100 Series switchers, follow these steps and see the appropriate section of this manual for details:

Step 1

Turn all of the equipment off and disconnect the power cords.

Step 2

Mount the switcher (if applicable) or affix the rubber feet to the bottom of the switcher for tabletop use. See page 2-2.

Step 3

Attach the cables. See the instructions beginning on page 2-5.

Laptop

Projector

1		2
		INPUTS			OUTPUT
	AUDIO INPUTS		AUX/MIX	OUT	CONTROL/
1	2	L 3 R L 4 R	MONO L	R	POWER

A B

MLS 102 VGA

NOTE Ground all devices. If you use cable that has a drain wire, tie the drain wire to ground at both ends.

To connect a computer or third party control system, see page 2-8.

MLS 102 VGA	External
	Power Supply

VCR Unbalanced,

Stereo Input

A B C D E A B C D E		1A 1B 2A 2B 3A 3B A B C D
IR	RS-232
Display/Source Control		Relays	IR/RCM

Wireless	Balanced/Unbalanced,
Microphone's	Mono Aux. Input
Receiver	Balanced/
	Unbalanced
	Output
	Amplifier

Extron Switcher Control		33-644-01A 07 01 Printedinthe USA
1 2 3 4 5 6	A B
Tally Out	MLS/Power

MLC 206 Bottom Panel

AUX/MIX

MONO

For the Aux/Mix Mono audio input, connect a 3.5 mm, 3-pole captive screw connector to one end of an audio cable as shown at right. This line level input can be balanced or unbalanced. Wire the other end to one tip-ring-sleeve connector.

The Aux/Mix level must be adjusted (-43dB to +24dB) via the front panel control. It cannot be adjusted via software.

Tip (+)

Gnd (Sleeve, )

Ring (–)

Aux/Mix Input Wiring

(balanced/unbalanced, mono)

MLS 100 Series• Quick Start Guide QS-1