Extron electronic P/2 DA6XI, P/2 DA4XI manual Description, Features, Installation, Rack mounting

Description

The P/2 DA4xi and P/2 DA6xi VGA-UXGA are high performance distribution amplifiers featuring one input/four outputs and one input/six outputs, respectively. Both P/2 DA units accept a VGA-UXGA video signal from a computer and distribute the signal to individually buffered outputs and one buffered loop-through. Each output is extendable up to 250' (76.2 m) with Extron’s VGA cables.

Examples of typical installations are shown in the diagrams on the following pages.

Features

•

•

•

•

•

Bandwidth — 300MHz (-3dB) RGB video bandwidth, fully loaded

Video Gain switch — Selectable video gain of 0.7 V or

1 V (when the input signal is 0.7 V p-p) to compensate for long cable runs

Power LEDs — Conveniently located on both front and back panels

Versatile mounting options — A metal enclosure and a wide variety of mounting options

ID bits pass through

Installation

The P/2 DA4xi and P/2 DA6xi can be mounted on a rack shelf, under-desk or through-desk.

Rack mounting

To install and set up the P/2 DA4xi or P/2 DA6xi on a rack, follow these steps:

1.Power off the computer and its local monitor.

2.For rack mounting, mount the unit on one side of an optional 6" Deep 1U Rack Shelf Kit (part #60-190-10), 6" Deep Basic Rack Shelf (part # 60-604-10), or other 9.5" deep rack shelves (part #60-190-01 or 60-604-01). See the illustration on the following page.

a.If rubber feet were installed on the bottom of the case, remove them.

P/2DA4xi/6xi • DescriptionInstallation 1