P/2 DA4xi and P/2 DA6xi, cont’d
b.Mount the unit on the rack shelf, as shown above, using two
6" Deep Rack Shelf | 1/2 Rack Width Front False |
| Faceplate |
Front false 
faceplate uses 2 screws.
(2)
Use 2 mounting holes on opposite corners.
3.Connect the computer’s VGA output to the input of the distribution amplifier.
4.Connect a monitor to the Local Monitor output of the distribution amplifier.
5.Connect LCD panels,
6.Connect power to the distribution amplifier.
7.Power on the local monitor, display device(s) and computer.
Under-desk mounting
1.If rubber feet were installed on the unit, remove them.
2.Attach the mounting brackets to the unit with the machine screws provided (see the following illustration).
3.Hold the unit with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.
4.Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep in the mounting surface at the marked screw locations.
5.Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4" of the screw head protrudes.
6.Align the mounting screws with the slots in the brackets and place the unit against the surface, with the screws through the bracket slots.
7.Slide the unit slightly forward or back, then tighten all four screws to secure the unit in place.
Through-desk mounting
1.Loosely attach the mounting brackets to the unit using the four machine screws and washer supplied with the mounting kit.
2.Insert two screws on each side of the unit through the adjustable (slotted) holes on the brackets. See the illustration below.
2 | P/2 DA4xi/6xi • Installation | P/2 DA4xi/6xi • Installation | 3 |
