PS 123, cont’d
2. | Mount the PS 123 on the rack shelf, using two |
| screws in opposite (diagonal) corners. |
3. | If necessary, mount the half rack width false front panel |
| (included with the Universal Rack Shelf only) and/or the |
quarter rack width false front panel (included with the PS 123) to the shelf, using two
Under-desk mounting
In addition to using the PS 123 power supply on a rack or projector, it can also be mounted under furniture (such as a desk) using the MBU 125
1. | Attach the mounting brackets to the power supply with |
| the provided machine screws (figure 9). |
2. | Hold the power supply with the attached brackets against |
| the underside of the furniture. Mark the location of the |
| screw holes of the bracket on the mounting surface. |
3. | Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) |
| deep in the mounting surface at the marked screw |
| locations. |
5. | Align the mounting screws with the slots in the brackets |
| and place the power supply against the surface, with the |
| screws through the bracket slots. |
6. | Slide the unit slightly forward or back, then tighten all four |
| screws to secure it in place. |
Projector mounting
PMK 350
The PMK 350 is an
Extron
IPL T S2
Ethernet Control
InterfaceExtron
PS 123
Rear Plate | 12 VDC 3 A |
Power Supply |
4. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until just less than |
| 1/4" of the screw head protrudes. |
Extron PMK 350
Extron
MPA 122
Mini Power Amplifier
A122
MP
| P/S | 123 |
| Y | |
| SUPPL | |
| WER |
|
12 VDC | 3A PO |
|
|
|
Front Plate
Figure 9 — Under-desk mounting the PS 123
Figure 10 — Projector mounting the PS 123
Follow these steps to mount the PS 123 onto the PMK 350 bracket:
1. | Remove the front and back plates from the PMK 350 |
| (figure 10), using an Extron Tweeker or a #2 Phillips |
| screwdriver. Retain the screws to reattach the plates when |
| you are finished. |
2. | If necessary, remove the feet from the bottom of the PS 123. |
3. | Secure the unit to one side of the mounting tray, using two |
| of the |
4. | Place the PMK 350 around the projector ceiling mounting |
| pole (figure 10, above). |
10 | PS 123 12 VDC, 3 Amp Power Supply • User's Guide | PS 123 12 VDC, 3 Amp Power Supply • User's Guide | 11 |