PS 123, cont’d
5. | Assemble the | |
| following order (figure 11, below): | |
| a. | Pass the legs of the |
|
| the mount plate flange. |
| b. | Place the legs around the projector pole. |
| c. | Pass the legs through the holes in the contour base. |
NThe pole fits snugly into the depression in the center of the contoured base.
d. Pass the legs through the holes in the
•For a typical (1.5" to 2.0" diameter) pole — You can use the supplied square
•For a smaller pole — Locally obtain a square
Mount Plate
Flange
Contoured
Base
9. | Secure the front panel to the mounting tray with four of |
| the included #6 screws. |
10.If desired, choose one of the provided four sizes of self- adhesive cover sheets, and apply it to the underside of the mounting tray.
PMK 450
The Extron PMK 450 Easy Installation
| Top Plate |
| Pipe Collar and |
| Set Screws (4) |
| AC Power Cord |
Front Plate | Access Slot |
|
Security Screw |
Rear Plate |
Slotted Hole | ||
in PMK Tray | ||
Bracket Scre | ||
|
Ceiling
Pole
Figure 11 — Projector mounting the PS 123
6. | Align the two slotted holes in the bottom of the |
| bracket with the two slotted holes in the base of the tray. |
| Secure the |
| |
7. | Move the PMK 350 up to the desired location on the ceiling |
| pole, as close to the ceiling as desired. |
8. | Secure the |
| included hex nuts, washers, and lock washers. Tighten the |
| hex nuts securely. |
CBe sure to tighten the hex nuts securely enough that the PMK 350 does not slide down the ceiling pole. A socket wrench is recommended to tighten the hex nuts.
Extron | Extron |
IPL T S2 | PS 123 |
Ethernet Control | 12 VDC, 3 A |
Interface | Power Supply |
Bottom Plate
Filler Plate
Figure 12 — Components of the Extron PMK 450 kit
1. | Using a Phillips screwdriver, remove the front and rear |
| plates. |
2. | Using the provided security wrench, remove the security |
| screws from the sides. Slide the top plate and lift it away |
| from the bottom plate. |
3. | Loosen the four pipe collar set screws to allow the top |
| plate to move freely along the pole. |
12 | PS 123 12 VDC, 3 Amp Power Supply • User's Guide | PS 123 12 VDC, 3 Amp Power Supply • User's Guide | 13 |