Extron electronic QGE 100 manual Analog Monitor Cable with Ferrite, For an analog source computer

Digital Connections		Analog Connections
1	8	C1	C2

C5

9	17	24	C3	C4
	Female DVI Connector		Analog Portion of DVI Connector

Pin	Signal	Pin	Signal	Pin	Signal
1	TMDS data 2–	9	TMDS data 1–	17	TMDS data 0–
2	TMDS data 2+	10	TMDS data 1+	18	TMDS data 0+
3	Ground (2/4 )	11	Ground (1/3)	19	Ground (0/5)
4	TMDS data 4-	12	TMDS data 3-	20	TMDS data 5-
5	TMDS data 4+	13	TMDS data 3+	21	TMDS data 5+
6	DDC clock	14	+5 V power*	22	Ground (clock)
7	DDC data	15	Ground (for 5 V)	23	TMDS clock+
8	Analog V-sync	16	Hot plug detect	24	TMDS clock–

*Loop-through connection only; 5 V is provided by the source.

Pin	Function
C1	Red signal
C2	Green signal
C3	Blue signal
C4	Horizontal sync
C5	Ground

NOTE: Analog vertical sync is on pin 8.

4.Important: Clip the provided ferrite block (shown at right) around the digital or analog monitor cable next to the DVI-A plug that attaches to the rear panel DVI-I In connector (see figure 7, below). The ferrite suppresses high frequency noise.

15-pin HD Connector DVI-A Connector

To Source Computer

Ferrite

To QGE 100

DVI-I Out Port

Figure 7. Analog Monitor Cable with Ferrite

PERIPH PC

5. Connect the mouse of the source computer to the Periph mouse connector on the QGE rear panel (circled at right).

6. Connect the keyboard of the source computer to the Periph keyboard connector on the rear panel (circled at right).

7.Connect the video monitor of the source computer to the DVI-I Out port on the QGE rear panel.

•For a digital source computer, connect the DVI source computer monitor directly to the DVI-I Out port on the QGE rear panel.

•For an analog source computer:

1.Connect the provided DVI-A-to-15-pin HD adapter to the analog source computer monitor cable.

QGE 100 • Installation and Maintenance 11