Extron electronic RGB 112XI Cabling, Extron, Controls and Installation, cont’d, Front, Interface

Controls and Installation, cont’d

Through-desk mounting

To mount the interface through a desk or table using the through-desk mounting kit (Extron part number 70-077-02), do the following:

1.Attach the mounting brackets to the interface using four machine screws and washers (supplied with the mounting kit), as indicated in figure 2-8.

Figure 2-8 — Attaching the through desk brackets

2.Using the through-desk template on page A-6 to guide you, mark the four screw holes on the underside of the surface to which you are mounting the interface.

3. Drill four pilot holes, each 3/32" (2.4 mm) in diameter by 1/4" (6.4 mm) deep, where marked on the template.

4.Using the four wood screws provided, attach the brackets to the mounting surface, as shown in figure 2-9.

Figure 2-9 — Through-desk mounting

2-10 RGB 109xi and RGB 112xi • Installation

Cabling

Each interface can connect to the computer or workstation’s local monitor and to a projector or other display device.

Figures 2-10 and 2-11 show how to connect each of the interfaces.

1.Connect the local monitor’s video signal cable to the interface connector labeled “Buffered Local Monitor Output”.

				Extron
Front				RGB 109xi
	BMUOFFER			Interface
	INPUT
	NITOREDLO
	OUTPCUATL
	H.
	SHIFT
				Rear
	VGA	INTER RGB
			109xi
		FACE W
			/ADSP	DDSP SERR SPARE
			SOGOUT

		Sound System
	Power	or
Local Monitor	Monitor	Projector

PC

Figure 2-10 — RGB 109xi installation

Front			Extron
	OUTPCUATL	H.	RGB 112xi
	INPUT
	BUF
	MONFERE
	ITORDLO
		SHIFT	Interface
	or		VGA
			INTERFACEW/112xi
			RGB
			ADSP
			SOGOUT DDSP SERR SPARE
	MFTA

	Rear
		Sound
		System
	Power
SUN or SGI Computer	Monitor	or
		Projector
Figure 2-11 — RGB 112xi installation

RGB 109xi and RGB 112xi • Installation 2-11