Installation, cont’d
Final adjustments
1.When the speaker is in place, insert the audio wires into the back of the speaker as shown.
Extron
Negative | INPUT |
| |
Wire | Positive Wire |
Push down on the spring terminals at the back of the speaker, and insert
the wires. Release the springs to secure.
Figure 7 — Insert audio wires into the terminals
NIf the ends of the wires are damaged and need to be restripped, follow the instructions in the SI 26 and SI 28 User's Guide.
2. | Turn on the audio source and any associated devices. |
| Adjust the source and device settings as desired to get the |
| optimum audio output for your speaker application. |
3. | To adjust the speaker angle insert the allen hex tool into |
| the locking access, loosen the hex cap screw, and adjust to |
| the desired angle (see figure 8). Torque the hex cap screw |
| down clockwise until snug, about 6 to 8 turns, for the |
| speaker to sit securely in the desired position. |
Turn clockwise to tighten.
Figure 8 — Adjust speaker and lock in place
NAfter locking it into place, check that the speaker is secure and cannot be lifted from the wall mount assembly. If it does lift out, continue tightening down the hex cap screw until it is no longer possible to lift the speaker from the assembly.
4. | Replace the Extron logo, pressing it firmly into place. |
NFor speaker details, specifications, troubleshooting tips, and service access information refer to the
SI 26 and SI 28 User's Guide supplied with the speakers, or online at www.extron.com