SW2 DP • Setup Guide
The Extron SW2 DP is a two input, one output, DisplayPort switcher that switches DisplayPort video and embedded
NOTE: For full installation, configuration, and operation details, see the SW2 DP User Guide, available at www.extron.com.
Rear Panel Features and Connections
SW2 DP
INPUTS | OUTPUT | EDID | REMOTE |
POWER | 1 | 2 | DEFAULT |
12V | EDID | ||
0.6A MAX |
|
| |
|
|
| STORE |
|
|
| STORED |
1 | 2 | 3 | 4 | 5 | 6 |
Tx Rx G
7
A Power connector for 12 VDC, 1 A power supply | E |
B DisplayPort input connectors | E |
C DisplayPort output connector | G |
D EDID Store LED |
|
EDID Store button EDID DIP switch
Installation Steps
1.Turn off all of the equipment and disconnect it from the power source.
2.(Optional) Mount the switcher on a rack shelf or furniture.
3.Connect DisplayPort sources to one or both of the SW2 DP input connectors (B on the rear panel diagram above).
4.Connect a DisplayPort output device to the output connector (C).
5.Connect control devices: Connect your computer to either of the following SW2 DP communication ports to configure and control the switcher via SIS commands:
•
Connect the other end of the cable (terminated with the female
Protocol for the
•Config port — Connect a USB
panel USB connector (E on the front panel diagram on the next page) for USB control.
| Rear Panel |
TxRx G | Remote Port |
|
NOTE: If you use cable that has a drain wire, tie the drain wire to ground at both ends.
Ground (G) |
|
Receive (Rx) | Transmit (Tx) |
Transmit (Tx) | Receive (Rx) |
| |
| Connector |
Computer or
Control System
1