Logicube Omniclone Xi user manual Installing and Removing the Light Bar, Buttons and Interface

GETTING STARTED

If an error occurs during cloning, the Status indicator lights on the front panel will shut off. If one of the drives caused the error to occur, the Status LED of the drive will remain lit.

The AMBER light on the light bar lights up when the unit prompts the user to enter information during a cloning or diagnostic operation.

The RED light will come on if a problem is encountered during cloning or any other operation. If this occurs, check the screen for an error message and instructions on what to do next.

Installing and Removing the Light Bar

The light bar is attached to the back of the Omniclone Xi unit and can be removed if desired. This will not affect the performance of the unit.

1.To install the light bar on the OCXi or the OCX5i, it first needs to be attached to the back of the unit with four supplied thumb-screws.

NOTE: The OCX2i does not come with a light bar, though one can be purchased separately.

2.Attach the light bar’s power cable to the six-hole Molex™ connector that is located on the back of the unit to the right of the Compact Flash Drive slot.

3.Light bar removal is the opposite of installation.

Figure 2. Buttons and Interface

Logicube Omniclone Xi ™ User’s Manual 11