2. Getting Started (Fast Start)

Applying power to the Logicube Omniclone Xi™

The Logicube Omniclone Xi™ is able to detect whether an IDE (parallel) or Serial ATA (SATA) drive is attached to the Master or Target positions. The unit is capable of cloning to/from a SATA drive to an IDE drive and vice versa (as well as IDE to IDE and SATA to SATA).

NOTE: Never attach both an IDE and SATA drive to the same drive position. The unit can only handle one drive on each position.

Before applying power perform the steps listed below.

Connecting Parallel (IDE, EIDE, UDMA) Drives

1.Locate the Master position on the top of your Omniclone-Xi™ unit. You will notice three connections: One for a flat cable (the drive data cable) and another for a small drive power cable. Above is the third connector for the Serial ATA cable.

Note: The drive that is cloned from is always referred to as the Master drive and the drives that are cloned to are always referred to as the Target drives.

2.Attach the 5” UDMA ribbon cable and the drive Power cable to the connectors.

3.Connect the Master hard drive to the cables and verify that the drive’s jumper is set to Single Master.

4.Follow steps 1 – 3 to attach drives to the Target positions of the Logicube Omniclone Xi™.

5.Connect the AC Power Cord to the back of the Logicube Omniclone Xi™ and power-up the

Logicube Omniclone Xi ™ User’s Manual

7

Page 13
Image 13
Logicube Omniclone Xi user manual Getting Started Fast Start, Applying power to the Logicube Omniclone