![](/images/new-backgrounds/1190755/19075513x1.webp)
Installation and Operation, cont’d
EXT |
|
SW | |
012V. | ITCH |
5A | MAX |
|
| I |
| NP |
1 | UT |
S |
2
A ( | O |
|
LO | UTP |
|
CAL | UTS |
|
| MO |
|
| NIT |
|
| OR) |
|
| B | L |
R | S |
|
|
| |
| W2 | VGA | DA2 |
| |
|
| S/ |
| AF | |
|
|
| E |
|
|
|
|
| MOTE |
| |
| 1 | 2 |
|
|
|
|
| I | A S |
| |
|
|
|
|
|
Through-desk mounting
1.Hold the front panel of the switcher against the desk or table. Use a soft pencil to mark the
(22.5 cm x 2.9 cm) will be slightly larger than the switcher enclosure.
2.Cut out the material from the
3.Attach the
(part
4.Hold the switcher with attached brackets up against the underside of the desk or table. Use a soft pencil to mark the locations of holes for the screws that will attach the brackets to the desk.
5.Drill ¼" (6 mm) deep, 3/32" (2 mm) diameter pilot holes in the desk or table at the marked screw locations. The holes should be drilled from the underside or inside (concealed side) of the furniture, where the switcher will be located.
6.Attach the switcher to the desk/table with the provided
wood screws, as shown in the following illustration.
S | A |
UT | |
WIT O | |
| CH |
Through-desk mounting
7.To adjust the height of the switcher within the desk, slightly loosen the screws that attach the brackets to the switcher, adjust the height by sliding the switcher up or down, and retighten the screws.
SW2 VGA DA2 A /AF • Installation and Operation | SW2 VGA DA2 A /AF • Installation and Operation |