SW6 HDMI and SW8 HDMI • Setup Guide
The Extron SW6 and SW8 HDMI are six and eight input, one output,
This guide provides instructions for an installer to set up and operate these switchers. For full installation, configuration, and operation details, see the SW HDMI Series User Guide, available at www.extron.com.
Rear Panel Features and Connections
NOTE: | Figure 1 shows an SW8 HDMI, which has eight input connectors. The rear panel of the SW6 HDMI is identical except |
for the number of input connectors (six). |
6
0.3A MAX | INPUTS | OUTPUT |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| ||
|
|
| 1 | 2 | 3 | 4 | +V | 5 | 6 | 7 | 8 +V |
1 |
|
|
|
|
|
| TALLY OUT |
2 | 3 | 4 | 5 | 6 | 7 | 8 |
CONTACT
1 | 2 | 3 | 4 | G | 5 | 6 | 7 | 8 | G |
1 |
|
|
|
| 3 | 4 |
2 | ||||||
Figure 1. SW8 HDMI Rear Panel |
|
|
|
|
| |
A Female IEC power connector |
|
| D Contact closure port |
| ||
B HDMI input connectors |
|
| E | |||
C HDMI output connector |
|
| F Tally Out port |
|
SW8 HDMI
REMOTE
Tx Rx G
5
Installation Steps
1.Turn off all of the equipment and disconnect it from the power source.
2.Mount the switcher on a rack shelf or furniture (optional. See the SW HDMI Series User Guide for the procedure).
3.Connect HDMI input sources to one or more of the SW HDMI input connectors (B on the rear panel diagram in figure 1).
NOTE: | LockIt® cable lacing brackets, one for each HDMI input and output connector, are provided with the SW HDMI. |
These brackets can be used to secure the HDMI cables to the rear panel connectors to reduce stress on the HDMI | |
connectors and prevent signal loss due to loose cable connections. For information on attaching the LockIt brackets, | |
see the SW HDMI Series User Guide, available at www.extron.com. |
4.Connect an HDMI output device to the output connector (C). By default, the EDID of this device is stored at the HDMI inputs.
5.Connect control devices: Connect your computer to one of the following SW HDMI communication ports to configure and control the switcher via SIS commands:
zz
shared connector (E in figure 1), and the other end of the cable to your computer serial port. Protocol for the
zz Config port — USB
| Rear Panel |
TxRx G | Remote Port |
|
NOTE: If you use cable that has a drain
wire, tie the drain wire to ground at both ends.
Ground (G)
Receive (Rx) Transmit (Tx)
Transmit (Tx) Receive (Rx)
Computer or
Control System
1