Installation, cont’d
1. Elevated operating ambient temperature — If installed in a closed or
2. Reduced air flow — Install the equipment in a rack so that the amount of air flow required for safe operation of the equipment is not compromised.
3. Mechanical loading — Mount the equipment in the rack so that a hazardous condition is not achieved due to uneven mechanical loading.
4. Circuit overloading — Connect the equipment to the supply circuit and consider the effect that circuit overloading might have on overcurrent protection and supply wiring. Appropriate consideration of equipment nameplate ratings should be used when addressing this concern.
5. Reliable earthing (grounding) — Maintain reliable grounding of
Rack mounting
The XPA 1002 or XPA 2001 can be mounted in a rack shelf using the optional RSU 129 1U Universal rack shelf (Extron part
1. | If feet were installed on the bottom of the amplifier, |
| remove them. |
2. | Place the amplifier on one half of the rack shelf. Align the |
| front of the amplifier with the front of the shelf, and align |
| the threaded holes on the bottom of the amplifier with the |
| holes in the rack shelf. |
3. | Attach the amplifier to the rack shelf with the two |
| provided |
| from the underside of the shelf, and securely fasten them |
| into |
See the following illustration.
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
Front false faceplate uses 2 screws.
| (2) |
| Screws |
| NOTE: Using screws longer |
| than 3/16” will damage the |
| unit and void the warranty. |
| Use 2 mounting holes on |
| opposite corners. |
Rack mounting of the amplifier | |
4. | Attach the false front panel (provided with rack shelf part |
| |
| above), or install a second |
| side by repeating steps 1 through 3. |
5. Attach the rack shelf to the rack using four
Rack mounting ventilation recommendations
Excessive heat can decrease the optimal lifetime of the power amplifier. An over temp indicator LED on the front panel of the amplifier lights red whenever the recommended ambient temperature has been exceeded (see "Front Panel Features and Operation" in chapter 3).
To reduce the chances for an over temp condition, the XPA(s) should be arranged in a rack environment so that adequate airflow is available both above and below the XPA whenever possible. No more than two XPAs should be arranged one-
XTRA Series • Installation | XTRA Series • Installation |