Installation, cont’d
Lift Cover Straight Up
Remove (8) screws
10. Connect the black hot (line) and white neutral wires to the terminal block on the PCB using the 2 screws that were removed in step . Use the included zip tie wrap to secure the two wires together close to the terminals. See the following illustration.
WEnsure that you observe correct wire polarity. The following illustration shows the location of the hot
(L) and neutral (N) terminals.
| , 50 | |
1.3A |
|
|
100 |
| US |
| |
C | 17TT | 1 | |
OT | |||
AUDIO/VIDEO | |||
LISTED |
| LIMITER/ECT | |
APPARATUSPR | |||
|
| SIGNAL |
2
INPUTS2 1
LEVEL | 2 |
1 | 0 |
0 |
|
REMOTE
VOL/MUTE
10V
STANDBY
| 1002 |
XPA | |
| 2 WIRING |
CLASS | 2 |
OUTPUT | |
1 |
|
2 WIRING | |
CLASS |
|
Terminal Block |
| ||
|
| ||
LINE | L | Hot | |
NEUTRAL | N | Terminal | |
Neutral | |||
|
| ||
|
| Terminal |
3. Remove the 2 screws holding the hot (line) and neutral wires from the terminal block on the PCB.
Ground |
Wire Nut |
100- |
|
240V | 1. |
| 3A 50- |
| 60Hz |
Remove screws
(both sides) to release IEC connector plate.
Blue Wire Brown Wire
N | L | |
Remove nut | ||
|
Conduit Nut
EMT Adapter Plate
11. Connect the ground wire, as shown above, to the grounding stud on the bottom of the enclosure using the nut that was removed in step 4.
12. Replace the cover of the XPA by attaching the 8 screws that
4. Remove the ground wire nut from the grounding stud on the bottom of the enclosure, as shown above.
5. Remove the 2 screws from the IEC plate, and remove the IEC connector plate and the attached wires through the rear panel of the XPA, as shown above.
6. Thread the
7. Install the EMT adapter plate with conduit attached into the opening from which the IEC connector was removed. in step 5.
8. Slide the conduit nut over the bundle of wires exiting the
conduit and onto the conduit itself. Hand tighten the conduit nut to the conduit.
9. Attach the EMT adapter plate assembly to the XPA using the 2 screws that were removed in step 5.
were removed in step 2.
XTRA Series • Installation | XTRA Series • Installation |