Installation and Operation
MDA S
ERIES
Mounting the YCV 100, VYC 100N, and VYC 100P on a 1U standard rack shelf
Back of the rack installation
The YCV 100, VYC 100N, and VYC 100P can be conveniently mounted on the rear of a rack by using the Extron back of the rack mounting kit (MBB 100, Extron part
1.Attach the two back of the rack mounting brackets to the sides of the unit using the four included mounting screws.
IPA T
IPA
IPA T
IPA
2.Mount the unit on the rack using the two included rack screws. It can be vertically mounted facing in either direction, as shown here.
1
2
3 | INPUTS | + |
4 | + | |
|
| R |
| 5 | L |
|
| 6 |
|
| 7 |
|
| 8 |
|
| 1 |
|
| 2 |
|
| 3 |
|
| OUTPUTS |
|
| 4 |
|
| 5 |
|
| 6 |
|
| 7 |
|
| 8 |
|
| M |
|
| AV S |
|
| ERI |
|
| ES |
Furniture mounting
Furniture mount the YCV 100, VYC 100N, or VYC 100P using the optional MBU 123 mounting kit (part
1. | Remove rubber feet if they were previously installed on the |
| bottom of the unit. |
2. | Attach the furniture mounting brackets to the unit with the |
| machine screws provided. |
3. | Hold the unit with the attached brackets against the |
| underside of the table or other furniture. Mark the location |
| of the screw holes of the bracket on the mounting surface. |
4. | Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep |
| in the mounting surface at the marked screw locations. |
5. | Insert #8 wood screws into the four pilot holes. Tighten |
| each screw into the mounting surface until just less than |
| 1/4" of the screw protrudes. |
6. | Align the mounting screws with the slots in the brackets and |
| place the unit against the surface, with the screws through |
| the bracket slots. See the illustration below. |
7.Slide the unit slightly forward or back, then tighten all four
screws to secure the unit in place.
YCV 100, VYC 100N, VYC 100P • Installation and Operation | YCV 100, VYC 100N, VYC 100P • Installation and Operation |
