Faber 630003952 installation instructions For Installations with Liners

TOOLS NEEDED FOR INSTALLATION	RECOMMENDED ACCESSORIES AVAILABLE
• Saber Saw or Jig Saw	• Remote Blower
• Drill
• 1 1/4" Wood Drill Bit	900 CFM Blower - part # 630001732
• Pliers	1200 CFM Blower - part # 610000007
• Phillips Screwdriver	• Liners
• Wire Stripper or Utility Knife
• Metal Snips	Create a perfectly-sealed, non-combustible perimeter around the
• Measuring Tape or Ruler	Inca Pro 30. Depth adjustable from 21” - 25”.
• Level	ProLiner 36 Stainless - part # 620000301
• Pencil
• Caulking Gun	• Remote Wall Control
• Duct Tape	Provides easy access at your finger tips to the rangehood light
PARTS SUPPLIED FOR INSTALLATION	and speed controls by allowing you to install the control panel
	at another location of your choice - part # 620000542
• 1 Literature Package

PARTS NEEDED FOR INSTALLATION

•2 Conduit Connectors

•Power Supply Cable

•Screws to Reinforce Atttachment

•Scews for Field Wiring Box

•All Metal Ductwork

!WARNING

FOR INSTALLATIONS WITH LINERS

When building a custom hood, always follow all applicable codes and standards.

Inca Pro 30 can be used with custom hoods 30” wide and up.

Choose either a custom liner or our ProLiner designed for 36" wide installations. Liners create a perfectly-sealed, non-combustible finish for the underside of your custom/wood hood.

The ProLiners are made up of two sections: a larger, rear section (pre-cut out for insertion of the Inca Pro 30) and a front section for a total adjustable depth between 21" and 25".

Consider the shape, size, and weight of the Inca Pro 30 and Liner to determine the configuration of the custom/wood hood. See

RANGEHOODDIMENSIONSAND LINER DIMENSIONS on Page 4.

CUSTOM/WOOD

HOOD

INCAPRO 30

1.The custom/wood hood must have a sturdy base (3/4" plywood recommended) to accomodate the cut-out for the Inca Pro 30. The base must be recessed to accomodate the height of the Liner (see LINER DIMENSIONS on Page 4). The Liner attaches to the bottom of the base using screws appropriate for the size and material of your custom/wood hood. The Inca Pro 30 inserts into the cut-out in the Liner and base.

2.Position the rear section of the Liner so that it abuts the back edge of your custom/wood hood. Using a pen, trace the outline of the pre-cut out. Remove the Liner and proceed to MAKE YOUR CUT-OUTSon Page 6. Install both sections of the Liner and proceed to INSTALL THE RANGEHOOD on Page 7.

Version 03/08 - Page 5