USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel is located on the
Replacing the Halogen Lamp
Before you begin, make sure that the rangehood is turned off and that the other lamps have had sufficient time to cool. Halogen lamps burn extremely hot and serious injury could result from touching a hot lamp. Press and twist the lamp to remove. If this is difficult for you, you can remove the stainless bezel which is held in place by two screws (A in FIGURE 12). Remove the two screws and the bezel. Then remove the lamp and replace with a new lamp. Once the new lamp is in place, reinstall the bezel.
L MV
FIGURE 11
Light On/Off Button ( L )
On/Off switch for the halogen lights. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Variable Speed control for blower. Move the switch from the left to the right (LOW to HIGH speeds).
For Best Results
Start the rangehood several minutes before cooking to develop proper airflow. Allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Clean exte- rior surfaces with a commercially available stainless steel cleaner. Abrasives and scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces.
WIRING DIAGRAM |
HALOGEN LAMPS |
FIGURE 12
• This rangehood uses 45 watt Halogen Lamps. | Version 03/08 - Page 8 |
