2.The entire bottom of the rangehood must be removed for installation as indicated in FIGURE 6. Remove the grease filters USING TWO HANDS (one to hold the filter so that it doesn't fall on cooktop and one to turn the knob (A in FIGURE 7) by pulling the knob out and turning to the left.
FIGURE 6 |
3.Remove the grease filter divider (B in FIGURE 7) by first removing the plastic screw cover (C in FIGURE 7), then removing the phillips screw under the screw cover.
FIGURE 7
4.Remove the two philips screws (D in FIGURE 8). Remove the entire
bottom of the rangehood by pushing your thumb into the side holes (E in FIGURE 8) and pulling the sides free from the rangehood.
FIGURE 8
5. Fix the rangehood to the cabinet or custom hood using the four spring loaded brackets, two on each side of the rangehood. Using a philips screwdriver or drill, tighten the adjustment screws (F in FIGURE 9) until the brackets adhere tightly to the surface.
6.IMPORTANT: There are 6 holes (G in FIGURE 9) for screws (not provided) to reinforce the rangehood to your cabinet or custom hood. Use screws appropriate for the size and type of materials of your cabinet or custom hood.
FIGURE 9
7.If the optional remote wall control switch is being used, please follow the instructions included with the remote wall switch pack- age. After following those instructions, skip to step #9 below. If the optional wall control switch is not being used, continue to step #8 below.
8.Remove the wiring box cover by removing the two screws. (See FIGURE 10 for reference) Insert the cable of the remote blower into the knockout hole of the rangehood. Insert the power supply cable into the hole of the rangehood. Connect the green ground wire from the power supply to the ground screw. Connect the green ground wire from the remote blower to the other green ground screw. Con- nect the black remote blower motor wire to the brown rangehood wire with a
- white rangehood wire - violet rangehood wire
- 120-volt white supply wire
Connect the black power supply wire to the black rangehood wire with a
screw securely. Reinstall the baffle filters. Reconnect the power.
Twist on wire connectors should be suitable for connecting multiple wires of different sizes together.
9.Replace the bottom of the rangehood and reinsert the grease filter divider and grease filters.
10.Connect the ductwork to the rangehood and seal all connections with duct tape.
11.Turn the power supply on. Turn on the blower and light. If the rangehood does not operate, check that the circuit breaker is not tripped or the house fuse blown. If the unit still does not operate, disconnect the power supply and check that the wiring connections have been made properly.
�������� ������
���������������������� ������
������� �������������
���� | ���� |
������� | ���� |
��� | ������������ |
������ |
|
������ |
|
���
������ 
�����
�����
������������������
�������
FIGURE 10
Version 03/08 - Page 7
