Faber Agio installation instructions Ductless Installations

FIGURE 10

4.Remove the central support and control box by remov- ing the screws indicated in FIGURE 11. It is not necessary to remove the blower to perform this operation.

FIGURE 11

5.Attach the cover behind the exhaust grate with two silver screws supplied with the rangehood as indicated in FIGURE 12.

FIGURE 12

6.Reattach the control box and support. Make sure that the wiring harness is concealed behind the support.

7.Remove the field wiring compartment cover. Feed the Power Supply Cable through the electrical knockout.

8.Attach the backdraft damper to the proper exhaust open- ing using two silver screws supplied with the rangehood.

9.Attach the rangehood to the cabinet bottom. The four key holes slip onto the four screws mounted to the cabinet bottom. Tighten the screws.

10.Connect the Power Supply Cable to the rangehood. Attach the White lead of the power supply to the White lead of the rangehood with a twist-on type wire connector. Attach the Black lead of the power supply to the Black lead of the rangehood with a twist-on type wire connector. Connect the Green (Green and Yellow) ground wire under the Green grounding screw.

11.Replace the field wiring compartment cover. For duct- less installations, refer to the next section which discusses ductless installations. Replace the grease filters.

12.Turn the power supply on. Turn on blower and light.

IF THE RANGEHOOD DOES NOT OPERATE:

•Check that the circuit breaker is not tripped or the house fuse blown.

•Disconnect the power supply and check that the wiring connections have been made properly.

DUCTLESS INSTALLATIONS

For ductless installations, the blower must be positioned with the exhaust pointing forward ( so that the exhaust exits from the front grill ) before attaching the rangehood to the cabinet. Ductless installations require Charcoal Filters.

1.Remove both grease filters, the central support and the control box. Remove the two thumb screws on either side of the blower and remove the blower from the mounting guides as indicated in FIGURE 11.

2.Rotate the blower 180° so that the exhaust points out the front of the rangehood. Replace the two thumb screws and tighten so that the blower is securely fastened inside the rangehood as indicated in FIGURE 13. Reattach the control box and central support. Make sure that the wiring harness is concealed behind the central support.

FIGURE 13

3.For ductless installations, Charcoal Filters are required and must be installed before the grease filters are replaced. The charcoal filters attach to both ends of the blower as indicated in FIGURE 14.

FIGURE 14

Version 10/05 - Page 6