USE AND CARE CONTINUED - CONTROL PANEL
The hood can be operated from the control panel located on the right hand side of the hood or from the remote control. The FIGURE 11 is an illustration of the control panel. The hood can be turned on by pushing any speed button T1 thru T4 directly.
KEY | GREEN LED | FUNCTIONS |
|
| |||
L 0 / 1 Light |
|
|
| Turns lighting on and off. |
| ||
|
|
|
|
|
|
|
|
T1 0 / 1 Motor | ON | First speed (press button) |
| ||||
|
|
|
| When pressed for about 1 second, the motor is |
| ||
|
|
|
| switched off. |
|
| |
| FLASHING | 24 hour function (can operate all day and night to refresh |
| ||||
|
|
|
| and clean your home) |
| ||
|
|
|
| This is enabled by pressing the button for approximately 5 |
| ||
|
|
|
| seconds. It operates at 60 cfm with a noise level of just .5 |
| ||
|
|
|
| sones. This function can be enabled at any speed, even with |
| ||
|
|
|
| the hood turned off. To disable, press and hold the button for |
| ||
|
|
|
| approximately 5 seconds. |
| ||
|
|
|
|
|
|
|
|
T2 Speed | ON | Second speed (press button) | FIGURE 11 | ||||
|
|
|
|
|
|
| |
| FLASHING | 30 minute Delay Function |
| ||||
|
| ||||||
|
|
|
| Press the button for 2 seconds to enable a 30 minute delay mode with automatic | |||
|
|
|
| shut off. This function is used to eliminate any residual odors for 30 minutes. This | |||
|
|
|
| can be enabled at any speed, even with the hood turned off and is disabled by | |||
|
|
|
| pressing the Speed 1 (On/Off) button for one second. |
| ||
|
|
|
|
| |||
T3 Speed | ON | Third speed (press button) |
| ||||
|
|
|
|
| |||
T4 Speed | ON | Max. speed (press button) |
| ||||
| FLASHING | Intensive Boost Function |
| ||||
|
|
|
| Use this function to eliminate the strongest cooking vapors and odors. Press the | |||
|
|
|
| button for 2 seconds to enable the Intensive boost. After 10 minutes of intensive | |||
|
|
|
| power, the motor turns off automatically. This function can be enabled from any | |||
|
|
|
| speed even with the hood turned off, and is disabled by pressing any | |||
|
|
|
| speed buttton. |
| ||
|
|
|
|
| |||
S1 Red Led | ON | Indicates that the Metal grease filter saturation alarm has |
| ||||
|
|
|
| been triggered, and the filters need to be washed. The alarm |
| ||
|
|
|
| is triggered after 100 working hours. (To Reset; see the |
| ||
|
|
|
| Maintenance paragraph) |
| ||
| FLASHING | Indicates that the charcoal filter saturation |
|
alarm has been triggered, and the filter has to be replaced; the metal grease filters must also be washed. The
charcoal filter alarm is triggered after 200 working hours when using a ductless installation. (For Activation and to Reset; see the Maintenance paragraph)
Version 09/05 - Page 8