USE AND CARE CONTINUED - MAINTENANCE
Cleaning
Thestainlesssteelgreasefiltersshouldbecleanedfrequentlyin hot detergent solution or washed in the dishwasher. Stainless steel cleaner should be used on stainless rangehoods. Abrasives and scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces. The inside of the ducting panels (FIGURE 12) should be cleaned with a damp cloth and a neutral dish detergent. Do not use wet sponges or cloths or jets of water; do not use abrasive substances.
Grease Filter and Charcoal Filter Alarm Reset
To reset the metal grease filter alarm and the charcoal filter saturation alarm, turn off the motor and lights. Press and hold the speed 3 button for a minimum of 3 seconds until the LED's start to flash.
FIGURE 12
Charcoal Filter Information
The charcoal filters should be replaced (as indicated in FIGURE
9)when the S1 LED light flashes or at least every 4 - 6 months depending on heavy usage. The alarm only comes on when the motor is turned on.
To replace the charcoal filter, open the ducting panels, remove the metal grease filters and remove the old charcoal filters and replace with the new ones. Then replace the metal grease filters and close the ducting panels.
Charcoal Filter Alarm Activation
The filter alarm has to be activated in order to use with ductless installations which use the charcoal filters. The alarm can be activated upon installation or at a later time. To activate or de- activate the alarm turn off the motor and lights, and disconnect the hood from the power source by disconnecting the main switch located on the left side of the motor housing. Press and hold the T1 (speed 1) button and while holding down the T1 button, reconnect the power source. All 5 LED lights will then turn on and within 3 seconds press and hold the T1 button (speed 1) until the LED's on T1 (speed 1) and T4 (speed 4) flash to confirm the chosen setting:
LED flashes twice - Charcoal filter saturation alarm ENABLED LED flashes once - Charcoal filter saturation alarm DISABLED
Repeat the process if you want to change the chosen setting, ie if the filter alarm is disabled, repeat the above paragraph to enable. Once finished with the activation /
Replacing the Lamps
Remove the light cover (as indicated in FIGURE 13) by removing the screws on the light bar. Remove the lights from the housing and replace the lamp with a 20 W
FIGURE 13
WIRING DIAGRAM |
• This rangehood uses 20 watt halogen lamps.
Version 09/05 - Page 9
