PREPARE THE WALL
1.Disconnect and move freestanding range from cabinet open- ing to provide easier access to rear wall. Put a thick, protective covering over cooktop,
2.Determine and clearly mark with a pencil the center line on the wall where the rangehood will be installed.
3.Draw a horizontal line at 43" above the cooktop (as indicated in FIGURE 4). Mark two points (1) (in FIGURE 4) on the horizontal line, 7 7/8" away from the center line on each side. Make sure both marks are level.
4.Mark two points (2) (in FIGURE 4) which are 19 7/16" above the cooktop, and are 7 1/16" on either side of the center line. Make sure both marks are level.
WARNING: THE SCREWS PROVIDED FOR MOUNTING THIS RANGEHOODMUSTBEINSERTEDINTOSOLIDWOOD. THESE MUST NOT BE INSERTED INTO SHEET ROCK.
B
F |
|
G | 43" |
| |
19 7/16" | 15" |
FIGURE 4
5.In holes (1) (in FIGURE 4) attach the two mounting brackets
(B) to the wall with 2 mounting screws.
6.In holes (2) (in FIGURE 4) put one safety screw (G) in each
hole, do not tighten the screws all the way.
4.Hang the rangehood on the two mounting screws and from the inside of the hood, adjust the mounting screws to make the hood level (B in FIGURE 5).
5.Tighten the safety screws (Hole 2, in FIGURE 4)
6.For ducted installations, the DAMPER (J in FIGURE 1) must be attached to the exhaust opening at the top of the CANOPY SECTION. Connect the ductwork and seal all connections with duct tape.
FIGURE 5
FIGURE 6
INSTALL THE RANGEHOOD
1.Open the ducting panels on the rangehood. Disconnect the 4 panels from the hood by sliding the fixing pin lever (as indicated in (A) FIGURE 5).
2.Using two hands, remove the grease filters one at a time by pushing the filter forward and and pulling the handle down. (FIGURE 6)
3.Adjust the two adjusting screws on the mounting hardware (B in FIGURE 5) to the lowest point
FOR ALL INSTALLATIONS
1.Remove the cover from the Field Wiring Compartment with a phillips screwdriver. Feed the Power Supply Cable through the electrical knockout. Connect the Power Supply Cable to the rangehood cable. Attach the Power Supply Cable grounding lead to the green screw provided. Attach the White lead of the power supply to the White lead of the rangehood with a
Version 09/05 - Page 6