PREPARE THE WALL
1.Disconnect and move freestanding range from cabinet opening to provide easier access to upper cabinet and rear wall. Put a thick, protective covering over cooktop,
2.Determine and clearly mark with a pencil the center line on the wall where the rangehood will be installed.
3.TheNovaattachestothewallbythreemountingbrackets, points 1, 2 and 3 in FIGURE 5. The canopy of the rangehood hangs from two metal flanges that extend from bracket #1. This bracket must be mounted with the flanges on the bottom of the bracket. The dimensions in FIGURE 5 are for mounting the canopy 24" above the cooking surface.
If a backsplash is to be used with this rangehood, it must be installed before the rangehood. Installation instructions for the backsplash are supplied in its box. The height of the backsplash will determine the bottom edge of the canopy.
FIGURE 5
4.The chimney attaches to the wall by two additional brackets, points 2 and 3 in FIGURE 5 which illustrates the positioning of the chimney brackets. The largest bracket, #2, should be installed about 1/8" away from the ceiling. The middle bracket ( bright metal ) must be installed with the ends touching the wall and the curves facing outward. The middle bracket must be installed at the bottom point of the upper chimney sleeve.
Determine the proper location for each bracket and install the brackets on the wall. MAKE SURE THAT THE BRACKETS
ARE SECURELY FASTENED TO THE WALL.
5.Determine and make all necessary cuts in the wall for the ductwork. Install the ductwork before the rangehood.
6.DeterminetheproperlocationforthePowerSupplyCable as indicated in FIGURE 6. Use a 1 1/4" Drill Bit to make this hole. Run the Power Supply Cable. Use caulking to seal around the hole. DO NOT turn on the power until installation is complete. For remote blowers, a separate wiring cable is required. DO NOT WIRE THE REMOTE BLOWER INTO THE FIELD WIRING HOUSING OR CONNECT WITH THE POWER SUPPLY CABLE.
90 cm 35 3/8" or 30"
FIGURE 6
INSTALL THE RANGEHOOD
1.Remove the unit from the carton and place on a flat surface for assembly. Cover the surface to prevent accidental damage. Remove all parts including the mounting hardware before discarding the carton.
2.Remove the grease filters from the unit and set aside. The grease filters are removed by pressing the handle in front of the filter as indicated in FIGURE 7. When replacing, make sure that the filters are properly positioned with the handles in front and visible.
FIGURE 7
Version 11/00 - Page 5
