Fagor America FSV-144US Installation Instructions, Before Using Your Wine Cooler

INSTALLATION INSTRUCTIONS

BEFORE USING YOUR WINE COOLER

Remove the exterior and interior packing.

Before connecting this appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR WINE COOLER

This appliance is designed to be for free standing installation or built-in (fully recessed).

Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded. To level your Wine Cooler, adjust the front leveling legs at the bottom of the Wine Cooler.

Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. Because of these factors this unit is not designed for use in a garage or any other outside installation.

Avoid locating the unit in moist areas.

Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center. This unit is not designed to be installed in a motor home or used with an inverter.

After plugging the appliance into an outlet, the unit should be allowed to cool for 3 ~ 4 hours before placing bottles in the appliance to ensure it reaches an appropriate, stable temperature.

BUILT – IN CABINET INSTRUCTIONS

This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built- in application please follow the requirements shown below.

← Figure shown

Cabinet Opening Dimensions

	IN (min)	MM (min)
Width	24”	610 mm
Depth	24”	610 mm
Height	35”	889 mm

			Figure shown →
	Unit Dimensions
		IN (min)	MM (min)
Width		23 2/5”	589 mm
Depth		20 4/5”	528 mm
(without handle)
Depth		22 ¾”	578 mm
(with Handle)
Height		34 1/4”	870 mm
			6