UNVENTED NATURAL GAS FIREPLACE
INSTALLATION
Continued
INSTALLING SCREEN
WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.
Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 47).
Notches
Screws for Mounting Screen
Figure 47 - Installing Fireplace Screen
INSTALLING BATTERY INTO REMOTE
1.Locate slot at bottom of remote control (see Figure 48). Firmly insert tool such as a small screwdriver, butter knife, or dime into the slot and lift up to remove cover.
2.Insert supplied battery into remote control. Positive and negative are marked inside remote control casing. Note: Remote will not function if bat- tery is not installed correctly.
3.Slide tab on cover into remote housing and snap cover back into place.
Tab
OPERATING
FIREPLACE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.
A. | This appliance has a pilot which lights | |
| automatically when using the sup- | |
| plied wall switch or remote control. | |
| If you have a power outage, the pilot | |
| may be lighted by hand with push- | |
| button piezo ignitor. When lighting | |
| the pilot, the following warnings | |
| must be followed. | |
B. BEFORE LIGHTING smell all | ||
| around the appliance area for gas. Be | |
| sure to smell next to the floor because | |
| some gas is heavier than air and will | |
| settle on the floor. | |
| WHAT TO DO IF YOU SMELL | |
| GAS | |
| • | Do not try to light any appliance. |
| • | Do not touch any electric switch; |
|
| do not use any phone in your building. |
| • Immediately call your gas supplier | |
|
| from a neighbor’s phone. Follow |
|
| the gas supplier’s instructions. |
| • | If you cannot reach your gas sup- |
|
| plier, call the fire department. |
C. Electric Power Outage Only: Use only | ||
| your hand to turn the manual over- | |
| ride handle on the gas control knob. | |
| Never use tools. If the knob will not | |
| turn by hand, don’t try to repair it, | |
| call a qualified service technician or | |
| gas supplier. Force or attempted re- |
NORMAL LIGHTING
INSTRUCTIONS
WARNING: You must operate this heater with the fireplace screen in place. Make sure fire- place screen is in place before running heater.
NOTICE: During initial operation of new heater, burning logs will give off a
1.STOP! Read the safety information, in column 1.
2.Make sure equipment shutoff valve is fully open.
3.Wait five (5) minutes to clear out any gas. Smell for gas around heater and near floor. If you smell gas, STOP! Follow “B” in the safety information on warnings plate. If you don’t smell gas, go to the next step.
A. Using Supplied Wall Switch
1. Set manual ignition bypass switch on |
the control panel to the OFF position |
(automatic ignition position). |
2. Press ON/OFF button. Hold for 6 |
seconds. Gas valve will open and elec- |
tronic ignition will begin sparking to |
light pilot. LED will light. |
Note: You may be running this |
heater for the first time after connect- |
ing to gas supply or at the start of |
your heating season. If so, the ON/ |
OFF button may need to be pressed |
again. This will allow air to bleed |
from gas system. If several attempts |
to light pilot fail, contact a qualified |
Slot
Cover
pair may result in a fire or explosion. |
D. Do not use this appliance if any part |
has been under water. Immediately |
call a qualified service technician to |
inspect the appliance and to replace |
any part of the control system and |
any gas control which has been un- |
service person or gas supplier for re- |
pairs. Until repairs are made, light |
and operate manually (see Manual |
Lighting Instructions for Electric |
Power Outage, page 21). |
3. When pilot flame is lit, the thermo- |
couple is heated by the flame. When |
thermocouple becomes hot (5 to 15 |
Remote
PositiveControl
Negative
Figure 48 - Installing Battery
der water. |
seconds), main burner will automati- |
cally light on high flame. |
For more information, visit www.desatech.com | 20 | 107569 |