OWNER’S MANUAL
INSTALLATION
Continued
4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the cross- over log lines up with rectangular knobs on top of the middle and front logs (see Figure 42).
Front Log (#3)
Recess
Post
Post
Figure 41 - Installing Front Log (#3)
Crossover
Log (#4)
Rectangular
Knobs
Figure 42 - Installing Crossover Log (#4)
INSTALLING LOGS (EFP33NR)
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: Do not remove the warning and instruction labels attached to the heater base as- sembly. These markings contain important warranty information.
WARNING: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Place the base of the middle log (#1) in the
2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 44).
3.Locate the notches in the bottom of the front log (#3). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers (see Figure 45).
Middle Log (#1)
Burner
Figure 43 - Installing Middle Log (#1)
4.Place crossover log (#4) onto the peg (right) on back log (#2) and into the re- cess of the middle log (#1) (see Figure 46).
Back Log (#2)
Peg
Peg
Figure 44 - Installing Back Log (#2)
Front Log (#3)
Notches
Grate Fingers
Figure 45 - Installing Front Log (#3)
Crossover Log (#4)
Peg
Recess
Figure 46 - Installing Crossover Log (#4)
Continued
107569 | 19 | For more information, visit www.desatech.com |