OPERATING INSTRUCTIONS cont.
OPERATING INSTRUCTIONS cont.
WINDING & UNWINDING THE POWER CORD
This vacuum cleaner is equipped with a convenient cord storage feature. The power cord winds around the two cord holders at the back of the unit. The bottom one has a quick cord release feature.
Turn the cord hook to the left or the right to remove the power cord. See illustration at right.
ON/OFF SWITCH
•The On/Off switch has two different positions.
•Push on the "I" side to turn the vacuum ON.
•Push on the "O" side to turn the vacuum OFF.
=OFF
= ON
USING THE UNIT AS AN UPRIGHT
•Unwind the power cord and plug into the 120V outlet.
•Push down on the locking button to adjust the height of the telescopic handle.
NOTE: When vacuuming deep pile carpets or hard to vacuum carpets, lower the angle of the telescopic handle (see illustration at
right) for easier maneuverability.
USING THE UNIT AS A HAND VACUUM
•Press the telescopic tube release button to remove the telescopic tube. (See page 4)
•Press the floor brush release button to remove the floor brush. (See page 4)
•Attach the shoulder strap to the shoulder strap attachment point. (See illustration below.)
•Attach the crevice tool or the dusting brush to the end of the hose.
WARNING
After extended use, the body of the vacuum cleaner may become hot. When using the unit with the shoulder strap, the unit will touch the body of the user. Therefore, make sure that the unit body is cool before you use with the shoulder strap. If during use, the vacuum gets too warm, allow it to cool before continuing to use.
Crevice Tool
For radiators, crevices, corners, baseboards and
between cushions.
Dusting Brush
The dusting brush is used for the furniture, venetian blinds, books, lamp shades and shelves.
Intelli-SenseTM Filter Monitor
When the
Air Driven Turbo Brush
Using The Unit With Air Driven Turbo Brush
The efficiency of your air driven turbo brush depends on the bristle brush rotating at high speed. Strong air suction is needed to accomplish this. In order to ensure that maximum air suction is maintained, please read the following instructions:
1.Empty the dust cup frequently.
2.Always shake out the dust cup filter when emptying the dust cup container.
3.Ensure that the rotating brush is kept free of hair and string which may accumulate and decrease brush performance.
4.Keep Air Driven Turbo Brush turbine free of dirt and foreign matter. (See illustration for cleaning instructions.)
Attaching the Air Driven Turbo Brush to the Flexible Hose
To use the air driven turbo brush to clean upholstery:
1.Remove the flexible hose from the hose connector. (See below)
2.Push the air driven turbo brush onto the end of the flexible hose as far as it will go.
Important: In order to ensure that maximum air suction is maintained, empty the dust cup frequently and ensure that the rotating brush is kept free of hair and string which may accumulate and decrease brush performance.
Cleaning Air Driven Turbo Brush
Locking Latch
Tilt
Upwards
Turbine
From time to time, the turbine of your turbo brush will require cleaning. To do this:
1.Remove the turbo brush from the hose or extension tube.
2.Slide locking latch forward then tilt the top housing of the brush upwards. The top housing is hinged and will tilt up approximately 45° only.
3.There may be some dust, lint, hair, etc on the turbine wheel. Remove as much of this as possible.
4.You may also use the unit’s hose with crevice tool attached and use the vacuum to remove any additional debris from the turbine.
5.Ensure that the turbine wheel moves freely by rotating it with your finger. If the turbine does not rotate, call Customer Service for help.
6.Once clean, close the top cover of the turbo brush and slide the locking latch toward the rear of the brush to lock.
5
6
