Part II: System Setup

SYSTEM SETUP

Your Faria Antares unit should already have been setup by either the boat manufacturer or by your dealer. Check with your dealer before beginning the System Setup process.

In order to get the optimal performance out of your Faria Antares unit, the following steps are recommended. Some of the information needed to complete the setup process will be contained in your boat owner’s manual. Be sure to have your boat owner’s manual available before beginning the Antares setup process.

To begin, use the left or right arrows on the navigation pad to highlight the

Antares Menu Screen on the screen indicator bar located at the bottom of the screen. Then use the down arrow on the navigation pad to scroll down to SYSTEM

SETUP and press .

Use the navigation pad to highlight SYSTEM SETUP, then press .

Step 1: INPUT SETUP

Use the navigation pad to highlight INPUT SETUP, then press .

Input Setup will allow you select which analog senders are connected to your Antares unit.

To activate or deactivate a sender, use the left or right navigation buttons to select either TANK 1, TANK 2, TRIM / TANK 3, AIR TEMP or SPEED SOURCE. Once the

desired selection is highlighted, press . Now use the up or down navigation buttons

to highlight the desired setting, then press . The icon on the Save Changes bar

will automatically highlight. If your changes are correct, press to save. will appear to confirm that changes have been saved. If the changes are

not correct, use the navigation pad to highlight and press .

will appear to confirm that the changes have not been saved. Refer to the list of available INPUTS on the next page for further instructions.

6

Page 8
Image 8
Faria Instruments IS0250a owner manual System Setup, Input Setup