Faria Instruments IS0250a owner manual Gimble Mount

Gimble Mount

Step 1: Locate a flat surface on your boat’s console to install the Antares Gimble Mount Bracket.

Step 2: Using a 3/16” drill bit, drill two holes 2.7” inches apart as indicated in the figure below.

Step 3: Using the supplied mounting hardware, mount the Gimble bracket through the holes you just drilled

Step 4: Using the supplied fasteners, mount the Antares unit into the Gimble bracket.

Step 5: Connect 9-pin (HN0604) and 20-pin (HN0605) wire harnesses to back of Antares unit. Proper connection requires the locking ring on each harness to be rotated about ¼ turn.

Step 6: Connect available inputs to corresponding wire harnesses. See pages 34-37 for detailed wiring information

34