Fellowes P-35C English, Set Up, Capabilities, IMPORTANT SAFETY INSTRUCTIONS — Read Before Using

A.

B.

C.

D.

E.

ENGLISH

Model P-35C

F.
G.
H.
I.
	KEY
	A. Shredder head	F. Disconnect power switch	I. Control Switch
	B. Sheet capacity icon	G. Handle	R	1.	Reverse
	C. See safety instructions below	H. Paper/Card entry	0	2.	Off
	D. Bin		I	3.	Auto-On
	E. Safety lock

To set lock slide button down

SET UP

Disconnect power switch must be in ON (I) position to operate shredder.

For safety reasons, shredder will operate only if the shredder head is in correct position and used with supplied basket.

CAPABILITIES

Will shred: Paper, credit cards, staples, and small paperclips

Will not shred: Unopened junk mail, continuous forms, adhesive labels, transparencies, newspaper, CD/DVDs, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:
Cross-Cut	4 x 40mm

Maximum:
Sheets per pass	......................................................................................................5*
Cards per pass	1*
Paper width	222mm

*70g A4 paper at 220-240v, 50Hz, 0.8Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 10-20 paper passes; 10 cards.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

•	Keep away from children and pets. Keep hands away from
	paper entry. Always set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. –
	away from shredder openings. If object enters top opening,
	switch to Reverse (R) to back out object.
• Never use aerosol products, petroleum based lubricants or other
	flammable products on or near shredder. Do not use canned air
	on shredder.
•	Do not use if damaged or defective. Do not disassemble
	shredder. Do not place near or over heat source or water.
• Operation, maintenance, and service requirements are covered
	in the instruction manual. Read the entire instruction manual
2	before operating shredders.

•This shredder has a Disconnect Power Switch (F) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.

•Avoid touching exposed cutting blades under shredder head.

•Shredder must be plugged into a wall outlet or socket of the voltage and amperage designated on the label. The outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product.

•FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.

•For indoor use only.