Fellowes P-35C Operation, Troubleshooting, Maintenance, Limited Product Warranty, Oiling Shredder

OPERATION

Continuous operation:

3-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 3 minutes will trigger

30 minutes cool down period.

PAPER
1	2	3	4

Set to Off (O)	Set to Auto-On (I)	Feed into paper	Set to Off (O)
and plug in		entry and release	and unplug
CARD
1	2	3	4	5
Set to Off (O)	Set to Auto-On (I)	Hold card at edge	Feed card into center	Set to Off (O)
and plug in			of entry and release	and unplug

Safety Lock prevents accidental operation. To set, wait for shredding to stop, set control switch to Off (O) position, then slide black button down. To unlock, slide black button up. For greater safety, always unplug shredder after use.

TROUBLESHOOTING

Paper jam: Set to Off (O), lift head and empty bin. Replace head on bin and follow any or all of the below procedures.

123 4

Set to Reverse (R)	Set to Off (O)	Gently pull uncut paper	Set to Reverse (R)
for 2-3 seconds	and unplug	from paper entry. Plug in.

MAINTENANCE

Shredder doesn’t start:

Make sure switch is in auto position (I).

Make sure safety lock is in unlock position.

Make sure head is on basket correctly. Check for jam.

Remove and empty basket.

Wait 30 minutes for motor to cool down.

OILING SHREDDER

All cross-cut shredders require oil for peak

performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately

stop running. To avoid these problems, we

recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1	2	3

Set to Off (O)	*Apply oil across entry	Set to Reverse (R)
		for 2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

LIMITED PRODUCT WARRANTY

Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 1 year from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for 3 years from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs

incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

3