6 |
| F M 1 0 0 H A m p l i f i e r |
| ||
|
Your new FM 100H amplifier delivers
•100W output power into 4 ohms
•Selectable Normal and Drive channels with independent volume and tone controls
•MORE DRIVE
•
•Classic Fender® spring Reverb
•Fender®
•
•FOOTSWITCH jack for use with a
Thank you for choosing
NOTE: The footswitch and power cord are stored behind the front grille of the FM100H cabinet. Access by pulling on both tabs at the bottom edge of the grille.
F ro n t P a n e l
12
INPUTS
VOLUME | TREBLE | MID | BASS |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| CH SELECT | MORE DRIVE |
|
|
| MID | |||||||||||
DRIVE |
|
|
|
| VOLUME |
|
| TREBLE |
| MID | CONTOUR | ||||||
|
|
|
|
|
|
|
|
|
|
| BASS |
REVERB | FOOT | PRE | PWR |
|
SWITCH | OUT | IN | FENDER MUSICAL INSTRUMENTS |
A.INPUTS - Plug your guitar in here: INPUT 1 is normal sensitivity for most guitars, INPUT 2 is lower sensitivity for guitars with high output (active) pickups.
B.VOLUME - Adjusts the loudness of the Normal channel.
C.TREBLE/MID/BASS - Adjusts the tone of the Normal channel in the high/middle/low frequency ranges.
D.DRIVE CHANNEL INDICATORS -
Yellow LED ON | Drive channel is active |
Red LED ON | More Drive channel is active |
E. DRIVE - Adjusts the distortion level of the Drive channel.
F. CHANNEL SELECT -
Button OUT |
|
|
| selects the Normal channel |
|
|
| ||
|
|
| ||
Button IN |
|
| selects the Drive channel | |
| ||||
| ||||
|
G. VOLUME - Adjusts the loudness of the Drive channel together with DRIVE {E}.
H. MORE DRIVE - Boosts the intensity and range of the
DRIVE control {E}. |
| |||
Button OUT |
|
|
| selects the Drive channel |
|
|
| ||
|
|
| ||
Button IN |
|
| selects the More Drive channel | |
|
| |||
|
|
I.TREBLE/MID/BASS - Adjusts the tone of the Drive channel in the high/middle/low frequency ranges.
J.
K.REVERB - Adjusts the Reverb level for both channels.
L.FOOTSWITCH - Plug in the included
M.PRE OUT/PWR IN - (1) Effects Loop - Connect PRE OUT to an effects device input, then connect the effects device output to PWR IN. (2) Multiple Amps - Connect the primary amplifier’s PRE OUT to the auxiliary amplifier’s PWR IN. The primary amp is used to control all auxiliary amps. (3) Recording or Reinforcement - Connect PRE OUT to sound equipment’s input.
Both jacks use a TS
N.POWER INDICATOR - Illuminates when the amplifier is on.